Filter
Top Products
Hardware options installation 49
6.
Identify the expansion slot compatible with the new option, and then remove the cover opposite that
slot.
7. Install the expansion board.
8. Install the PCI riser cage (on page 22).
IMPORTANT: The server does not power up if the PCI riser cage is not seated properly.
9. Connect all necessary internal and external cables to the expansion board. For more information on
these cabling requirements, see the documentation that ships with the option.
10. Install the access panel (on page 20).
11. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack ("Installing the server into the rack" on page 28).
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server (on page 17).
Dedicated iLO management port option
To install the component:
1. Power down the server (on page 17).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following: