Filter
Top Products
Fingerprint reader
Description Spare part number
Fingerprint reader (includes bracket and cable) 763711-001
Before removing the fingerprint reader, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 31), and then remove the following components:
a. Optical drive (see
Optical drive on page 32)
b. Top cover (see
Top cover on page 39)
Remove the fingerprint reader:
1. Turn the top cover upside down, with the front toward you.
2. Remove the Phillips PM4.5x2.0 broadhead screw (1) that secures the fingerprint reader bracket to the
top cover. Remove the bracket (2), and then remove the fingerprint reader (3) (the cable was
disconnected from the system board when removing the top cover).
Reverse this procedure to install the fingerprint reader.
Component replacement procedures 49