Filter
Top Products
32
hp pavilion home pc
Filename: ma1rwtc.doc Title: HP-Print2k.dot
Template: HP-Print2K.dot Author: WASSER, Inc. Last Saved By: WASSER, Inc.
Revision #: 161 Page: 32 of 46 Printed: 04/26/01 09:20 AM
Country
Number of
attem
p
ts
p
er
sequence
Pauses
between
attempts
(seconds)
Pauses
between
sequences
(minutes)
Australia
New Zealand
10
10
3
60
30
60
Bell Compatible Operation
Bell compatible mode should not be used. Nearly all
modems use CCITT mode because Bell mode is limited to a
maximum speed of 300 or 1200 BPS, and some network
interference problems may arise due to line signaling
requirements.
Parallel Telephones
If you find that you regularly experience line noise or other
interference when using your modem, we suggest
disconnecting other telephones from the line. Some
telephones may place a load across the telephone line when
not in use, which adversely affects the performance of your
modem.
If disconnecting parallel telephones reduces the interference,
then it may be necessary to have the telephone(s) repaired
or replaced.
Warnin
g
:
(
New Zealand users onl
y)
Please
note that operation of this modem on the
same line as telephones or other
e
q
ui
p
ment with audible rin
g
in
g
devices, o
r
automatic ringing detectors, may cause
“bell tinkle” or false tripping of the
ringing detector.
If this occurs, do not contact Telecom Faults
Service. Also, please note that the power
consumed from the telephone line by this
modem may not provide for the effective
transfer of a call to or from other
equipment connected to the same line.
Connecting to Other Equipment
There are two telephone line sockets in your modem,
marked LINE and PHONE. The telephone line is connected
to the LINE socket, and other equipment, such as the
telephone, is connected to the PHONE socket. Please note
that Austel permitted/NZ Telepermitted equipment only may
be connected to the PHONE socket.
Miscellaneous
There are many commands referred to in the main user’s
manual. Incorrect use of some of these commands may
render your modem inoperative or severely degrade its
performance. Generally, it is best not to change any setting
unless you are an experienced user.