Filter
Top Products
Smart card reader
Description Spare part number
Smart card reader (includes door and cable) 652672-001
Before removing the smart card reader, follow these steps:
IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 46).
5.
Remove the service door (see
Service door on page 52).
6.
Remove the hard drive (see
Hard drive on page 63).
Remove the smart card reader:
1.
If you need to replace the smart card reader door, close the door (1).
2.
Open the zero insertion force (ZIF) connector for the smart card reader cable (2) and then
disconnect the cable from the system board (3).
66 Chapter 4 Removal and replacement procedures