Filter
Top Products
2-13
R Class System Installation
3. Connect the Console, Web Console, or Graphics Monitor
IMPORTANT POWER ADAPTORS FOR THE REMOTE WEB CONSOLE:
The Remote Web Console, used with an R-Class server in either a racked or stand-
alone configuration, receives power from a special power adaptor included with
your shipment.
The localized power adaptor included in the Remote Web Console box is qualified
for use ONLY for stand-alone (non-racked) servers. Do not use this power adaptor
for racked server solutions.
Racked servers, whether pre-integrated at the factory or rack-mounted at the
customer site, must instead use the auto-ranging R Class Web Console Power
Adaptor (HP Part No. 0950-3415) included in the server accessories box. This
power adaptor can be secured to the rear of the server chassis using the Velcro strips
attached there (refer to the figure on page 2-10).
Do not discard the auto-ranging power adaptor even if the server is configured
as a stand-alone unit. If the server is rack-mounted at a later date, the auto-ranging
power adaptor will be needed to provide the proper power supply to the Remote
Web Console.
Configure the Remote Web Console using the instructions provided in its shipping
box.