Filter
Top Products
2. Write down tape I/O Configuration from the ISL utility MAPPER.
a. Press CTRL - B to put the system in control mode.
b. Enter TC and press RETURN to soft reset the system.
c. Press any key to override the autoboot.
d. Enter Y for Boot from the primary boot path (Y or N)? or if
prompt shows BO PRI. Press RETURN.
e. Enter Y for Interact with IPL (Y/N)?.
f. At the ISL prompt, enter:
ISL>ODE
ODE>MAPPER
MAPPER>RUN
g. After MAPPER scans system I/O configuration, you get the output similar to
the following:
Figure 3 I/O configuration: SCSI tape library
Find the tape device and write down the I/O path and component name.
3. Restart the system and log in.
NOTE:
Do not stream jobs or start network interface and network services.
MPE/iX system user guide 27