Filter
Top Products
Device management
Device management includes monitoring the operating status of devices and configuring their running
parameters.
NOTE:
The configuration tasks in this document are order independent. You can perform these tasks in any order.
Configuring the device name
A device name identifies a device in a network and works as the user view prompt at the CLI. For
example, if the device name is Sysname, the user view prompt is <Sysname>.
Follow these steps to configure the device name:
To do… Use the command… Remarks
Enter system view system-view —
Configure the device name sysname sysname
Optional
The default device name is HP.
Changing the system time
You must synchronize your device with a trusted time source by using NTP or changing the system time
before you run it on the network. Network management depends on an accurate system time setting,
because the timestamps of system messages and logs use the system time.
In a small-sized network, you can manually set the system time of each device.
Configuration guidelines
You can change the system time by configuring the relative time, time zone, and daylight saving time. The
configuration result depends on their configuration order (see Table 11). In the first column of this table,
1 represents the clock datetime command, 2 represents the clock timezone command, and 3 represents
the clock summer-time command. To verify the system time setting, use the display clock command. This
table assumes that the original system time is 2005/1/1 1:00:00.
Table 11 System time configuration results
Command Configuration exampleEffective system time System time
1 date-time
clock datetime 1:00
2007/1/1
01:00:00 UTC Mon
01/01/2007
2
Original system time ±
zone-offset
clock timezone
zone-time add 1
02:00:00 zone-time Sat
01/01/2005
126