Filter
Top Products
ASUS A7V133-VM User’s Manual 31
3. HARDWARE SETUP
Connectors
3. H/W SETUP
10) Primary (Blue) / Secondary IDE Connectors (40-1 pin IDE1/IDE2)
These connectors support the provided UltraDMA/66/100 IDE hard disk ribbon
cable. Connect the cable’s blue connector to the motherboard’s primary (rec-
ommended) or secondary IDE connector, and then connect the gray connector
to your UltraDMA/66/100 slave device (hard disk drive) and the black connec-
tor to your UltraDMA/66/100 master device. It is recommended that non-
UltraDMA/66/100 devices be connected to the secondary IDE connector. If you
install two hard disks, you must configure the second drive to Slave mode by
setting its jumper accordingly. Refer to your hard disk documentation for the
jumper settings. BIOS now supports specific device bootup (see 4.6 Boot Menu).
(Pin 20 is removed to prevent inserting in the wrong orientation when using
ribbon cables with pin 20 plugged). If you have more than two UltraDMA/66/
100 devices, you will need to purchase another UltraDMA/66/100 cable.
NOTE: The hole near the blue connector on the UltraDMA/66/100 cable is
intentional.
TIP: You may configure two hard disks to be both Masters with two ribbon
cables – one for the primary IDE connector and another for the secondary IDE
connector. You may install one operating system on an IDE drive and another on
a SCSI drive and select the boot disk through BIOS 4.6 Boot Menu.
11) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
A7V133-VM IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Secondary IDE Connector
Primary IDE Connector
PIN 1
A7V133-VM
®
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
A7V133-VM Floppy Disk Drive Connector
PIN 1
A7V133-VM
®