Filter
Top Products
18 Interface Installation and Configuration Chapter 2
Note Refer to “Alternate Configurations” for information on using the E8491A
with the HP E1406 Command Module and using it in VXI-MXI systems.
A. If turned on, turn off the VXI mainframe and disconnect all power
sources that may be applied to any instruments.
B. Insert the E8491A into mainframe slot 0 by aligning the module with
the guides inside the mainframe (Figure 2-6). Slowly push the module
into the slot until it seats in the backplane connectors. It may be
necessary to pull out (not remove) the retaining screws in order to
seat the device securely in the connectors.
Figure 2-6. Installing the HP E8491A in the VXI Mainframe.
seat the module by
pushing in the
extraction levers
extraction
levers
slide the module
into the mainframe
until it plugs into the
backplane connectors
retaining
screws