Filter
Top Products
Removal and replacement procedures 31
Front panel/hard drive cage assembly
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all hard drive blanks ("Hard drive blank" on page 25).
5. Remove all hard drives ("Hard drive" on page 25).
6. Disconnect the SAS/SATA cables and power cable from the hard drive backplane, and then remove
the front panel/hard drive cage assembly.
To replace the component, reverse the removal procedure.
Heatsink
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
To remove the component:
1. Power down the server blade (on page 22).
2. Remove the server blade (on page 23).
3. Remove all hard drive blanks ("Hard drive blank" on page 25).
4. Remove all hard drives ("Hard drive" on page 25).
5. Remove the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on
page 31).
6. Remove the access panel ("Access panel" on page 24).