Filter
Top Products
C100_110-160_180.FB 4 Tue Jul 16 06:36:50 1996
4
Preparing Your Workstation
5 If your system has an A4070B HCRX-8Z or an A4071B with the A4272A accel-
erator graphics adapter installed enter the following commands to save the cur-
rent versions of the /etc/ioconfig and /stand/ioconfig files:
mv /etc/ioconfig /etc/ioconfig.old
mv /stand/ioconfig /stand/ioconfig.old
6 Power off your workstation by pressing the power button on the front panel.
When you press the power button, the workstation automatically shuts down the
operating system before it powers off the system.
7 When the workstation has completed shutting down and powering off, power off
the monitor, and any peripheral devices connected to the workstation.
If your system has supported graphics adapters installed, continue with step
8. Otherwise skip to step 12.
8 If a message to press Esc to stop the boot process is displayed, then press Esc.
This stops the boot process and brings you to the Boot Console Handler prompt.
9 At the prompt, enter the following command to enter the information menu:
in
10 Enter the followiong command to display the console setting:
co
The garphics path for the default console device is displayed. Make note of this
information below for later use.
Console Path: ________________________________________
11 Power down the system.