HP (Hewlett-Packard) C6N73UARABA Personal Computer User Manual


 
8.
Slide the TouchPad button board bracket (3) up and away from the top cover until the tabs (4) on
the front edge of the bracket disengage from the slots (5) on the top cover.
Reverse this procedure to install the TouchPad button board.
Solid-state drive
Description Spare part number
180-GB solid-state drive for use on all computer models 699330-001
160-GB solid-state drive for use on all computer models 681997-001
32-GB mSATA solid-state drive for use only on computer models equipped with an Intel processor 682099-001
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 47), and then remove the following components:
a. Hard drive (see
Hard drive on page 48)
b. Optical drive (see
Optical drive on page 53)
72 Chapter 4 Removal and replacement procedures