Filter
Top Products
Upgrading and Servicing Guide 7
2 Press inward on each side of the bracket brace (3),
and lower the bracket until it snaps into place over
the diskette drive. Ensure that the guide screws (4)
are installed in the adapter.
3 Return to “replacing or adding a drive” on page 5,
and begin with step 1.
2
2
1
3
2
4
replacing the diskette drive adapter on the
8000 series
upgrading or replacing
memory
Your PC comes with random access memory (RAM),
which temporarily stores data and instructions on your
PC. You can install memory expansion modules in the
memory expansion slots in the PC. The procedures for
upgrading or replacing these modules are the same
for the S0000 and 8000 series.
removing a memory module
CAUTION: When handling a memory
module, be careful not to touch any of the
contacts. Doing so may damage the
module.
1 Complete the procedure described in “preparing
the pc” on page 1, but do not remove the front
bezel.
2 Locate the memory module inside your PC. See the
following illustration for the location of the memory
modules (1), memory slots (2), and release latches
(3) on the system board.
locating the memory module
NOTE: The location and number of memory
modules may vary slightly by model.
3 Open both latches of the memory module socket
(1) found at each end of the memory module. Lift
the memory module (2) from the memory slot.
removing a memory module