Filter
Top Products
3. Lift the left side of the hard drive cover (2), swing it forward, and remove the cover (3). The hard
drive cover is included in the plastics kit, spare part number 595200-001.
4. Remove the three Phillips PM2.5×5.0 screws (1) that secure the hard drive to the computer.
5. Use the hard drive bracket to lift the hard drive out (2) of the hard drive compartment.
6. Disconnect the hard drive cable from the system board (3).
7. Remove the hard drive (4) from the hard drive bay.
8. To replace the hard drive bracket, remove the four Phillips PM3.0×4.0 screws (1) that secure the
hard drive bracket to the hard drive
48 Chapter 4 Removal and replacement procedures ENWW