Filter
Top Products
3. Disconnect the display panel cable (1) and the microphone cable (2) from the system board and
remove it from its routing channel.
4. Pull the antenna cables through the opening in the top cover (3) and disengage the cables from
the clip in the routing channel leading to the display hinge (4).
5. Disconnect the webcam cable (5) from the system board and release it from the clips that attach
it to the system board.
CAUTION: Support the display assembly when removing the display screws in the following
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
6. Remove the four black Phillips PM2.5×7.0 screws (1) that secure the display assembly to the
computer.
ENWW Component replacement procedures 71