Filter
Top Products
HP 10/100 3Com 3C905B-TX Network Interface Card Installation Guide
HP Support Services
18 English
The PC Cannot Be Started or Woken-Upfrom the Network
1
If the PC has been powered off (for example, due to an electrical
power failure, or because the power cord has been removed), the
Remote Power On (RPO) will not work. To enable the RPO, you must
first power on the PC, allow the Operating System to boot, then shut
down the PC.
2
Check that the WOL connector cable is connected to the network
interface card and to the PC’s system board.
3
Check that the LAN-specific fields in the HP PC Setup utility are
correctly set (refer to refer to “Updating LAN-specific Fields in the
HP PC Setup Utility” on page 9.)
NOTE RPO is only supported under Windows 95, Windows 98 and Windows
NT 4.0.
HP Support Services
The latest drivers and utilities are available on HP’s Web site at:
For HP Vectra PCs www.hp.com/go/vectrasupport
For HP Brio PCs www.hp.com/go/briosupport
For HP Kayak PC
Workstations
www.hp.com/go/kayaksupport
3com.bk : 3com-us.fb4 Page 18 Monday, February 15, 1999 3:14 PM