Filter
Top Products
35
Using HP OBDR
Compatibility
HP One-Button Disaster Recovery is a standard feature on all HP StorageWorks DAT
autoloaders. However, it can only be used with specific configurations and will only recover
the server to which the autoloader is directly connected.
To check whether your system (hardware, operating system and backup software) is OBDR-
compatible, please refer to our World Wide Web site
www.hp.com/go/connect.
For more specific information concerning the benefits of OBDR and the latest new features
please refer to our World Wide Web site
www.hp.com/go/obdr.
Note HP OBDR is not applicable to HP-UX and other non-Intel UNIX operating systems, and it is not
compatible with Intel-based Solaris systems. HP OBDR is supported on a server with a RAID
controller if the autoloader is connected directly to a host bus adapter (HBA).
If your system does not support HP One-Button Disaster Recovery, you can still use your
autoloader normally to back up and restore data. However, you must remember to create a
separate set of emergency recovery disks for your operating system whenever you change
your system configuration.
What does HP OBDR do?
Using just the autoloader and the most recent backup cartridge HP OBDR allows you to
recover from the following types of system disaster:
• Hard disk failures, as long as the replacement hard disk is the same size or larger than the
original and uses the same interface (for example, replace a SCSI hard disk with another
SCSI disk)
• Hardware failures where the server is replaced by an identical component
• File corruption because of an operating system error
• File corruption because of an application software error
• Viruses that prevent you from booting your system correctly
• User errors that stop you from booting your system correctly
When you run HP One-Button Disaster Recovery, your autoloader goes through the following
sequence:
1 It goes into a special disaster recovery mode that enables it to restore your operating
system and reboot. It acts like a bootable CD-ROM. (Your system’s ability to boot from
CD-ROM is normally enabled by default. If you have changed this setting, you will need
to enable it again. Refer to your system BIOS manual for further details.)
2 It returns to normal autoloader mode and restores the data.
Remote disaster recovery (ProLiant servers only)
The HP Remote Insight Lights-Out Edition (RILOE) on ProLiant servers gives the IT Administrator
the ability to completely recover a failed server at a remote location without physically
traveling to where the server resides. The on-site non-technical person need only insert the
bootable cartridge into the autoloader when asked to do so by the administrator.
Refer to the HP OBDR web site at
www.hp.com/go/obdr for more information about using
this feature and compatibility.
autoload_master-frame6.fm Page 35 Monday, December 29, 2003 9:39 AM