Filter
Top Products
Page 2
Front panel
Back panel
Installing the server into the rack
NOTE: Depending on the rail assembly provided, your slide
rails may vary slightly from those in the following illustrations.
CAUTION: Always install the heaviest item first, and continue
to populate the rack from bottom to top.
1. Install the slide rails:
a. Attach the slide rails, as shown:
• For hardware-mounted assemblies (A), mount the slide
rails onto the rack using the supplied screws and star
washers. For square-hole racks, use the provided locator
washers.
• For click-and-snap assemblies (B), hook the slide rails onto
the rack. At both ends of the slide rail, push the outer
spring latch 1, and then slide the spring mechanism
toward the rail end until the rail is secure 2.
IMPORTANT: For hardware-mounted rails, HP
recommends
leaving the screws loose until the server is completely
installed. This eases installation by preventing binding of the server
in the rack.
1 Slim DVD-ROM
2 Individual HDD status LED
3 2 USB ports
4 Overall HDD activity LED
5 Overall HDD fault LED
6 NIC LEDs
7 UID LED
8 Power LED
9 UID button
10 Power button
11 HDD bays (0-3)
1 Dual USB port
2 PS/2 mouse port
3 NIC connectors (RJ45) (1-2)
4 UID LED
5 Low profile, half length PCI-X
slot
6 Full height, full length PCI-X slot
7 AC power connector
8 PS/2 keyboard port
9 Serial port
10 D-sub VGA port
10699
3 4 8
10
6
5 7 9
1 2
11
10700
8 9
531 42 6 7
10
5201A
1
2
A
B