Filter
Top Products
Page 3
b. Locate the inner slide rails:
• On hardware-mounted assemblies, remove the inner slide
rails from the outer slide rails. To do so, extend the inner
slide rails from the front of the rack until they lock in place.
Then, press the inner slide lock down, as shown, and pull
the inner slide rails straight out.
• On click-and-snap assemblies, the inner slide rails arrive
separate from the outer slide rails.
2. Prepare the server:
a. Attach the two thumbscrew brackets to the server using the
supplied bracket screws, as shown 1.
b. Attach a slide rail (lock facing out) to each side of the server,
insert the slide rail screws through the slide rails, and then
tighten, as shown 2.
c. Attach the bezel 3 to the thumbscrew brackets, and then lock
(if desired).
3. Install the server:
a. With the outer slide rails extended a short distance from the
rack, insert the inner slide rails (with the server attached) into
the outer slide rails, as shown 1. Press the inner slide lock 2,
and then push the server all the way into the rack, making
sure that the inner slide rails lock into place.
b. Slide the server in and out of the rack several times, allowing
the slide rails to position properly 1.
c. Lock the server in place using the thumbscrews 2.
10685
5202
1
1
2
3
2
5203A
2
1
5204
2
1