Filter
Top Products
Chapter 1 15
Installation and Setup
Turning on the Analyzer for the First Time
Turning on the Analyzer for the First Time
❏ Plug in the power cord.
WARNING If this product is to be energized via an external auto transformer for
voltage reduction, make sure that its common terminal is connected to a
neutral (earthed pole) of the power supply.
CAUTION The analyzer is shipped with a a transportation disk inserted in the disk
drive to prevent damage to the disk drive during transportation. This
transportation disk, or a blank floppy disk, should be inserted in the disk
drive whenever transporting the analyzer.
NOTE Do not connect anything else to the analyzer yet.
❏ Choose a power on preference using the switch on the rear panel (refer to Rear-Panel
Features, on page 33, item 14). The
PWR ALWAYS ON setting turns the analyzer on
whenever external power is applied. This mode is useful if an external power switch is
used to control a rack of several instruments. Nevertheless, if you set the analyzer to
standby using the front panel
Standby key (see Rear-Panel Features, on page 33, item
23) and the external power is removed and restored within 20 seconds, the analyzer will
remain in standby.
The
PWR NORM setting assigns analyzer on/off control to the front-panel On and Standby
keys (see “Front-Panel Connectors and Keys” on page 26, item 23). If the analyzer is on
and the external power is removed and restored within 20 seconds, the analyzer will
turn on. On the other hand, if the external power is removed and restored after 20
seconds, the analyzer will remain in standby regardless of the front-panel switch
settings.
❏ Press the
| (On) key to turn the analyzer on.
Information Screen
An information screen appears during the initialization process. The information screen
contains the analyzer product number and a URL for accessing product support
information on the World Wide Web. See “Additional Information” on page 2.
NOTE The information screen displays for approximately 10 seconds before the
initialization process is complete.
Record the firmware revision and serial number, and keep it for reference. If
you should ever need to call Agilent Technologies for service or with any
questions regarding your analyzer, it will be helpful to have this information