Filter
Top Products
4
Installation Procedures
Installation Procedures
Figure 1 HP9000/K570 Rear View
7. Remove the adjoining processor slot’s cover plate by loosening the two (one top and one
bottom) captive mounting screws and pulling the cover plate away. (This is necessary to
gain access to the system board.)
8. Reach into the computer cabinet and remove the plastic dust cover from the HP-HSC
expansion connector on the system board.
9. Remove the plastic dust cover from the Dual Bus 4-Slot HP-HSC Expansion I/O Card
connector.
10.Align the Dual Bus 4-Slot HP-HSC Expansion I/O Card into the card slot and slide it
into the computer.
11.When the card makes contact with the system board connector, press the edge of the
card to fully seat the card into the computer. Tighten the two captive screws to secure
the expansion I/O card.
12.Replace the CPU cover plate and tighten the two captive mounting screws.