Filter
Top Products
120 Removal and replacement
EN
Face-up/face-down lever
1 Remove all covers, the RFI shield, the printer door, the exit roller,
the delivery assembly, the fuser pressure plate, the front casing,
the heating element, and the pressure roller.
2 Rotate the lever forward 90 degrees (past the spring) and pull it
straight out the front of the printer.
To reinstall
1 Make sure the lever arm is on the left and is initially pointing
downward.
2 Pull the spring forward using needlenose pliers.
3 Slide the short, round tabs into the grooves on the separation
guide assembly. The machined ridges on the lever will face you.
4 Release the spring so it falls in place in front of the square tab.
Figure 48. Face-up/face-down lever replacement
Note You can tell when the lever is in place because there are two plastic
grooves that fit precisely in front of the exit rollers, and you should be
able to feel the spring’s release mechanism.
www.GovTechMedia.com