Filter
Top Products
Enable RAID through the system BIOS (f10)
NOTE: The following procedures assume that you are using the HDD image that shipped with your
computer. If a different image is installed on your computer, you must first enable RAID through the
system BIOS (f10), and then install the operating system and all required drivers, including the Intel
Matrix Storage driver. Then follow the steps in
Initiate RAID migration using Intel Matrix Storage Console
on page 14.
Users must enable RAID capability through the system BIOS to switch the SATA host controller for
RAID. The steps are as follows:
1. Turn on the computer, or restart it.
2. Press f10 as soon as the computer boots.
If you do not press f10 at the appropriate time, you must restart the computer, and then press
f10 again to access the utility.
3. In the system BIOS, select System Configuration > Device Configurations.
12 Chapter 5 RAID volume setup