Filter
Top Products
NOTE:
Memory configurations listed do not apply to "Factory Integrated Models".
DDR3 memory population guidelines
For detailed memory configuration rules and guidelines, please use the Online DDR3 Memory Configuration Tool:
www.hp.com/go/ddr3memory-configurator
Some DIMM installation guidelines are summarized below:
For servers with eighteen (18) memory slots:
There are three (3) channels per processor; six (6) channels per server
There are three (3) DIMM slots for each memory channel; eighteen (18) total slots
Memory channel 1 consists of the three (3) DIMMs that are closest to the processor
Memory channel 3 consists of the three (3) DIMMs that are furthest from the processor
DIMM slots that are white should be populated first
Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs)
Do not install DIMMs if the corresponding processor is not installed
If only one processor is installed in a 2CPU system, only half of the DIMM slots are available
To maximize performance, balance the total memory capacity between all installed processors
It is not required, but it is recommended to load the channels similarly if possible
You can only have up to eight (8) ranks installed per channel
You can only install two quad-rank DIMMs per channel
You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty
Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel
Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset
For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically
For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs. The paired slots will
be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system
No mixing DIMM voltage; all DIMMs must be the same voltage
DIMM slot/capacity/populated speed table
DIMM Type ->
Registered Dimms (RDIMMs)
Unbuffered with ECC DIMMs (UDIMMs)
DIMM Rank ->
Dual Rank (2R)
Quad Rank (4R)
Single Rank (1R)
Dual Rank (2R)
DIMM Capacity ->
2GB 4GB 8GB 2GB 4GB 8GB 1GB 2GB 1GB 2GB
DIMM Native Speed
(MHz) ->
1333 1333 1066
*
1066
*
1333
* *
1333
SLOTS THAT CAN BE POPULATED
18/12 slot servers
18 18 18
*
12
*
12
* *
12
*
MAXIMUM CAPACITY (GB)
18/12 slot servers
36 72 144
*
48
*
12
* *
24
POPULATED DIMM SPEED (MHz)
1 DIMM Per Channel
1333 1333 1066
*
1066
*
1333
* *
1333
2 DIMM Per Channel
1066 1066 1066
*
800
*
1066
* *
1066
3 DIMM Per Channel
800 800 800
* * * * * * *
* - not supported by HP at this time.
NOTES:
Mixing DIMM speeds is allowed, but the system processor speed rules always override the DIMM capabilities
QuickSpecs
HP ProLiant ML330 Generation 6
Memory
DA - 13361 Worldwide QuickSpecs — Version 5 — 7.13.2009
Page 27