Filter
Top Products
Adjusting the Projector32
Adjusting the shape of the picture
Depending on the type of video source you are viewing, the picture might or might not always
look correct or fit on the screen:
• If the active video device sends widescreen output to the projector, press enter, go to Input,
and set Widescreen input to Yes. See
1 in the following diagram.
• If the video device sends standard output, set Widescreen input to No.
TIP: If you show widescreen pictures on a wide projection screen, a standard picture might
not fit on the screen. One solution is to change the current picture mode so it makes a smaller
picture. Press enter, go to Picture > Customize picture mode, and set Aspect Ratio to Reduced.
See 2 in the following diagram.
Downloaded from www.Manualslib.com manuals search engine