Filter
Top Products
Setting Up the Monitor
3-4 User’s Guide
8. Slide the column mounting bracket away from the bottom of the monitor.
Sliding the column mounting bracket from the monitor
9. Remove the Compaq logo from the back of monitor to expose the top two threaded holes (A) and (B) for the wall
mount bracket. Place the tip of a small, flat blade screwdriver under the logo to pry it up.
Removing the logo from the back of the monitor
Use the four holes (A), (B), (C), and (D) to attach the swing arm or other mounting fixture to the back of the
monitor with screws (not supplied).
10. Follow the instructions included with the mounting fixture to ensure that the monitor is safely attached.
The four threaded holes that are on the back of the panel are compliant with the VESA standard for mounting
flat-panel monitors.
11. Attach a swing arm or other mounting fixture.
NOTE: The logo is held in place by rubber cement.
A
B
C
D