Filter
Top Products
Removing a hard disk drive from the slot load optical bay
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Remove the airflow guide (see
Removing the airflow guide on page 76).
4. Remove the expansion card support and any card cables that might interfere with slot load
assembly removal.
5. Disconnect the optical drive power cable from the chassis power cable, and the optical drive data
cable from the system board (see
Removing the slot load optical disk drive on page 99).
6. Disconnect the slot load drive data cable from the system board connector as shown in the following
figure.
Figure 5-45 Disconnecting the data cable from the system board
7. Disconnect the chassis power cable from the slot load drive power connector as shown in the
following figure.
Figure 5-46 Disconnecting chassis power cable from hard disk drive connector
ENWW Removing and installing components 111