Filter
Top Products
loading media
13Operator’
s Guide
g. Route the media liner (backing)
around the tear bar to the media
rewinder.
h. Place the clasp over the end of the
media, and rotate the media
rewinder a few turns.
i. Rotate the media guide up, and slide
it to the media’
s edge.
j. Lift and snap the lower right front
panel closed.
k. Raise the hinge plate, and latch the
printhead by rotating the printhead
latch clockwise to the latched
position.
l. Close the side cover.
note
It
is possible to use the present
sensor only (without inverting the
tear bar) to provide on-demand
label printing in the tear
-off mode.
T
o operate in this mode, media
should be routed as shown in
step f, and the Label Present
menu selection should be
enabled.