Filter
Top Products
Power cord requirements 31
Power cord requirements
Introduction to power cord requirements
The power cord set meets the requirements for use in the country where you purchased the equipment.
The voltage selection switch allows you to select the appropriate line voltage for the server.
Power cord sets for use in other countries must meet the requirements of the country where you use the
server. For more information on power cord set requirements, contact your HP authorized dealer.
General requirements
The requirements listed below are applicable to all countries:
• The length of the power cord must be at least 1.8 m (6.0 feet) and a maximum of 3.7 m (12 feet).
• The power cord set must be approved by an acceptable accredited agency responsible for
evaluation in the country where the power cord will be used.
• The power cord set must have a minimum current capacity and nominal voltage rating of
10A/125 volts AC, or 10A/250 volts AC, as required by the power system of each country.
• The appliance coupler must meet the mechanical configuration of an EN60320/IEC 320 Standard
Sheet C13 Connector, for mating with the appliance outlet on the computer.
Power cord set requirements by country
Use this table to identify the appropriate accredited agency in your country.
Country Accredited agency Applicable note numbers
Australia EANSW 1
Austria OVE 1
Belgium CEBC 1
Canada CSA 2
Denmark DEMKO 1
Finland SETI 1
France UTE 1
Germany VDE 1
Italy IMQ 1
Japan JIS 3
Norway NEMKO 1
Sweden SEMKO 1
Switzerland SEV 1