Filter
Top Products
Display assembly
Description Spare part number
12.1-inch, WXGA, BrightView, LED touch-screen display assembly (includes Web camera and cable,
microphones and cables, fingerprint reader and cable, WLAN antenna cables, and WWAN antenna
cables)
611492-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Battery on page 35).
5. Disconnect the WLAN antenna cables from the WLAN module (see
WLAN module on page 43).
6. Remove the hard drive (see
Hard drive on page 37).
7. Remove the top cover (see
Top cover on page 48).
Remove the display assembly:
1. Close the computer and turn it upside down, with the rear panel toward you.
2. Remove the two Phillips PM2.0×4.0 screws that secure the display hinge cover to the computer.
3. Turn the computer display-side up, with the rear panel toward you.
4. Open the computer display to the upright position and rotate the display (1) 90-degrees
clockwise.
ENWW
Component replacement procedures
55