Filter
Top Products
Pen holder and pen eject assembly
Description Spare part number
Pen holder and pen eject assembly 506826-001
Before removing the pen holder and pen eject assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Battery on page 35).
5. Remove the following components:
a. Pen (see
Pen on page 36)
b. Hard drive (see
Hard drive on page 37)
c. Memory module compartment cover (see
Memory module on page 41)
d. Optical drive (see
Optical drive on page 40)
e. Keyboard (see
Keyboard on page 46)
f. Switch cover (see
Switch cover on page 48)
g. Display assembly (see
Display assembly on page 50)
h. Top cover (see
Top cover on page 53)
i. Power switch assembly (see
Power switch assembly on page 55)
j. System board (see
System board on page 58)
Remove the pen holder and pen eject assembly:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the pen eject assembly to the
base enclosure.
2. Remove the pen eject assembly (2).
3. Remove the two Phillips PM2.0×3.0 screws (3) that secure the pen holder to the base enclosure.
Component replacement procedures 61