Filter
Top Products
Display assembly
Description Spare part number
12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, fingerprint reader,
microphones, and WLAN antenna cables
464144-001
12.1-inch, WXGA, BrightView touch-screen display assembly with Web camera, microphones, and
WLAN antenna cables
464142-001
12.1-inch, WXGA, BrightView touch-screen display assembly with fingerprint reader, microphones and
WLAN antenna cables
464145-001
12.1-inch, WXGA, BrightView touch-screen display assembly with microphones and WLAN antenna
cables
464143-001
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power cord.
4.
Remove the battery (see
Battery on page 36).
5.
Remove the memory module compartment cover (see
Memory module on page 41).
6.
Remove the WLAN module compartment cover and disconnect the wireless antenna cables from the
WLAN module (see
WLAN module on page 43).
7.
Remove the keyboard (see
Keyboard on page 47).
8.
Remove the switch cover (see
Switch cover on page 49).
Remove the display assembly:
1.
Close the computer and turn it upside down, with the front toward you.
2. Loosen the Phillips PM2.0×5.0 captive screw (1) that secures the display connector cover to the
computer.
3. Lift the rear edge of the display connector cover (2) and swing it toward you.
4.
Remove the display connector cover.
NOTE: The display connector cover is included in the Plastics Kit, spare part number 464114-001.
Component replacement procedures 51