Filter
Top Products
3
HP vc4815 Series Setup
(F10) Utility
Using HP vc4815 Series Setup (F10) Utility
The Setup utility can be accessed only by turning the computer on or
restarting the system. To access the Setup Utility menu, complete the
following steps:
1. Turn on or restart the computer.
2. When the F10 <BIOS Setup> message displays in the task bar
at the bottom of the screen, press the
F10 key.
✎ If you do not press the F10 key while the message is displayed, you
must restart the computer again to access the utility. When the F10
Post Screen display is set to zero seconds, it may be necessary to
press and hold
F10 on the keyboard, then power on the computer.
3. A choice of five menu headings and five task headings appears in
the Setup Utility menu:
Menu Headings: System Information, Standard CMOS Features,
Advanced BIOS Features, Integrated Peripherals, and Power
Management Setup.
Task Headings: Load Defaults Setting, Set Supervisor
Password, Set User Password, Save Setting and Exit, and
Exit without Saving.
Service Reference Guide www.hp. com 3-1