Filter
Top Products
Installation 17
Install and configure the disk array
The HP service representative performs these tasks:
• Assembling hardware and installing software
• Loading the microcode updates
• Installing the channel adapters (CHAs) and cabling
• Installing and formatting devices
After these tasks are finished, you will use Command View or LUN
Configuration Manager to complete the remaining tasks listed below. If
you do not have Command View or LUN Configuration Manager, your HP
service representative can perform these tasks for you.
Setting the Host Mode for the disk array ports
The disk array ports have Host Modes that you must set depending on the
host you use. Use Command View (shown) or LUN Configuration
Manager to set the Host Mode for each port. The host mode setting for
HP-UX is 08.