Filter
Top Products
Technology Code IC) Removal and Replacement 2-21
Figure 2-16. Removing Display Assembly Components
Reassembly Notes
• Make sure the alignment hole in the inverter PCA fits over the corresponding post in the display
case.
• Make sure the alignment hole in the wireless antenna fits over the corresponding post in the display
case.
• Set the bezel in place on the display, then work your way around the bezel, firmly snapping the
bezel latches shut.
• The rounded screw co
• vers go on the screws at the top of the display bezel, and the flat covers go on the screws at the
bottom of the bezel.
Screw, M2×4mm
Screws,
M2×4mm (2)
Screws,
M2×4mm (2)
Screws,
M2.5x6mm (4)
Inverter PCA
Bluetooth antenna
802.11b
antenna