Hitachi CP-S210 Projector User Manual


 
31
OPTION Menu
With the OPTION menu, the items shown in the table below can be performed.
Perform each operation in accordance with the instructions in the table below.
: SELECT
MENU
MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
VOLUME
SCREEN TYPE
LAMP TIME
FILTER TIME
RESET
16
4:3
1234h
21h
Item Description
VOLUME
Adjust Volume: High Low
SCREEN TYPE
Select the Screen Type:
4:3 16:9 16:9 16-9
Please select the screen type used and the picture position in case of 16:9.
This selection is used as basic information for a suitable display. This function
should be performed before other picture adjustment.
LAMP TIME
To begin the operation of this item, please press the button of the
projector or the RESET button of the remote control for 3 seconds.
Reset the Lamp Timer:
Selecting the RESET performs this function.
RESET CANCEL
The numerical value of four digits shown on this menu is the projector use
time since the last RESET operation of this item. The value is reset to 0 at the
same time the RESET is selected.
The value of this function is used to display the message of CHANGE THE
LAMP. So this function must be performed only immediately after replacing
the lamp.
Do not perform this function unless you have replaced the lamp. Perform this
function every time the lamp is replaced. Incorrect performing of this function
causes incorrect operation of the message function.
Please see to the section Lamp about replacing the lamp.
FILTER TIME
To begin the operation of this item, please press the button of the
projector or the RESET button of the remote control for 3 seconds.
Reset the Filter Timer:
Selecting the RESET performs this function.
RESET CANCEL
The numerical value of four digits shown on this menu is the projector use
time since the last RESET operation of this item. The value is reset to 0 at the
same time the RESET is selected.
The value of this function is used to display the message of CLEAN THE AIR
FILTER. So this function must be performed only immediately after cleaning
or replacing the air filter.
Do not perform this function unless you have cleaned or replaced the air filter.
Perform this function every time the air filter is cleaned or replaced. Incorrect
performing of this function causes incorrect operation of the message
function.
Please see to the section Air Filter about cleaning and replacing the air
filter.
RESET
Reset the OPTION Menu Items:
Selecting the EXECUTE performs this function.
EXECUTE CANCEL
The SCREEN TYPE item is returned to the initial setting. Note that the items
VOLUME, LAMP TIME and FILTER TIME are not reset.
Multifunctional Settings (continued)