Filter
Top Products
17
1
Press the STANDBY/ON button (control
panel or remote control)
The message "Power off?" will appear on the screen for
approximately 5 seconds.
3
Check that the STANDBY/ON indicator
stops blinking and lights to
solid orange.
Switch the power switch to
[O] (OFF).
4
Confirm that the STANDBY/ON indicator has
gone off and then attach the lens cap.
When the projector has completed powering down, the
STANDBY/ON indicator will go off.
TURNING OFF THE POWER
2
Press the STANDBY/ON button again
(control panel or remote control)
Press the STANDBY/ON button again while the "Power off?"
message is visible. The projector lamp goes off and starts cooling
down. While cooling, the STANDBY/ON indicator flashes orange.
When in this state, pressing the STANDBY/ON button has no
effect.
When lamp cooling is complete, the STANDBY/ON indicator stops
flashing, and turning solid orange.
•
Except in cases of
emergency, do not turn off
the power switch while the
STANDBY/ON indicator is
solid or flashing green.
Doing so could shorten
the lamp lifetime.
NOTE
Control panel
STANDBY/ON
INPUT
KEYSTONE
RESET
MENU
LANP
TENP
ONE TOUCH
RGB
BNC
DVI
VIDEO
S-VIDEO
COMPONENT
FOCUS ZOOM
STANDBY/ON indicator
STANDBY/ON
STANDBY/ON
STANDBY/ON
VIDEO
UP
DOWN
BLANK
ASPECT
PUSH
LASER
INDICATOR
LASER
RGB
FOCUS
ENTER
ON
OFF
ESC MENU RESET
POSITION
MAGNIFY VOLUME
MUTE
WIRELESS KEYSTONE
FREEZE
ONE TOUCH
AUTO
PinP
ZOOM
PAG E
power switch
Downloaded from www.Manualslib.com manuals search engine