Filter
Top Products
1-5
StarBoard
F
X
-77/F
X
-63/F
X
-82
W
Introduction
English
1.3 Assembly and Setup
When setting up the StarBoard, keep the following in mind:
• Select a level and stable position.
• Do not set it up near equipment that might generate electromagnetic waves and radio
frequencies (e.g. radio transmitter, television, copying machine, air conditioner).
• Avoid locations that are dusty, that are subject to extremely high or low temperature or
humidity or that are exposed to direct sunlight.
1.3.1 Stand Setup Method
Reconfirm that all parts are present before assembling and setting up the stand.
(1) Stand Assembly
Assemble the stand according to the following diagram. Numbers in the diagram
correspond to numbers in the parts list on page 1-2.
Long Short
Align both feet with the
longer side facing forward
Fasten with an
Allen wrench.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(9)
Fasten the screws tightly.
Otherwise, the stand might fall and cause injury or the impact of the falling board
might cause damage.
CAUTION
Fasten with a
Phillips screwdriver.
(7)