Hitachi 42HDW10 Computer Monitor User Manual


 
ENGLISH
23
TROUBLESHOOTING
Make the checks suggested below depending on the symptoms observed. If the
symptoms remain uncorrected, contact your dealer.
Symptoms That Seemingly Appear to be Failures
• Customer servicing can be hazardous.
WARNING
Symptom Point to check
See
page
No picture with the power-
indicating lamp off.
Check the way the power cable is connected.
Press the power switch.
The message POWER
SAVE is displayed.
No picture with the power
indicating lamp flickering in
green.
POWER SAVE
No sync signal is detected.
Check the way the signal cable is connected.
Make sure that the switch of the computer,
imaging equipment , etc., is turned on.
Make sure the computer is not in the power-save
mode.
Check to see if the input selection matches the
connection terminal.
The message OUT OF
FREQUENCY is displayed.
OUT OF FRQUENCY
An input signal is not received normally.
Check to see if the input signal matches the
monitor specifications.
Check the way the signal cable is connected.
The power indicating lamp is
normally lit but no picture .
Check the contrast and brightness settings
(adjust them for higher contrast and brightness).
Check the way the signal cable is connected.
The display image appears
flowing slantwise.
Text displayed across the
screen appears vertically
streaked, with the characters
in vertical columns blurred.
Adjust the dot clock frequency and phase.
(Adjust the dot clock frequency first, the dot clock
phase next.)
(RGB input)
Text displayed across the
screen appears blurred.
A fine pattern flickers when
displayed on the screen.
Adjust the dot clock phase for the clearest
viewing.
(RGB input)
The remote controller does not work.
Check to see if the batteries are loaded in the
remote controller in opposite direction.
Check to see if the batteries in the remote
controller are OK.
6
7
9
6
7
9
21
28
6
7
21
6
7
11
13
16
25
16
26
8
10
15
15