Hitachi CP-RX61 Projector User Manual


 
4
S-VIDEO VIDEO
AUDIO IN
OUT
RGB IN2 RGB OUT RGB IN1
CONTROL
Part names
Lens (
17, 46)
Lens cover (
6, 17)
Filter cover (
9, 10, 44)
(Air lter and intake vent
are inside.)
Elevator button (
12)
Elevator foot (
12)
Remote sensor (
8)
Focus ring (
20)
Vent (
10)
AC inlet (
16)
Power switch (
17, 18)
Elevator button (
12)
S-VIDEO port
(
15)
VIDEO port (
15)
CONTROL port (
14)
Part names
Projector
Lamp cover (
43)
(Lamp unit is inside.)
Elevator foot (
12)
Bottom side
Speaker
Front-Right side
Rear-Left side
Control buttons (
5)
Ports
(See below.)
Vent (
10)
Ports
Restart switch (
50)
Kensington lock slot
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
AUDIO-OUT port (
14)
AUDIO-IN port (
14)
RGB IN1 port (
14)
RGB IN2 port (
14)
RGB OUT port (
14)
Zoom ring (
20)