Filter
Top Products
Quantum System
Quick-Start Guide - Operator
7
Clean the Printhead
♦
The Printhead should be cleaned approximately once each week, or whenever unclear labels are printed.
It is a good idea to clean the Pressure Roller whenever a new roll of labels is installed.
♦
Do not use a metal tool on the Printhead; this could scratch or break the Printhead.
♦
Labels should not become stuck on machine parts. If they do, remove the labels at once, following the
instructions in the Printhead Cleaning Kit.
♦
To obtain a Printhead Cleaning Kit, contact your local Hobart office; request Part Number 00-184326.
TO CLEAN THE PRINTHEAD OR
PRESSURE ROLLER:
1.
Check the Printhead and Pressure Roller for
labels or adhesive before inserting every roll of
labels. Clean as needed.
2.
Remove the Label Cassette.
3.
Use the plastic “Lil’ ChiZler” in the Printhead
Cleaning Kit to remove stuck-on label stock.
4.
To remove burned-on adhesive, gently rub the
Printhead or Pressure Roller surface with the
eraser.
5.
Soak the cotton swab tip with the Printhead
Cleaning Solution.
6.
Scrub the Printhead or Pressure Roller with the
swab until all residue is removed.
7.
Moisten the swab as needed with Printhead
Cleaning Solution.
8.
Allow the Printhead or Pressure Roller to dry.
9.
Return the Cleaning Kit to its holding box.
10.
Replace the Label Cassette.
How to Start a Run
The following list gives you a brief overview of how each Weigh Type selection functions within an
operation. Use the UP ARROW (
) and DOWN ARROW (
) keys to move the cursor to the Weigh
Type you require. The RIGHT ARROW (
) and LEFT ARROW (
) move between the columns.