Filter
Top Products
3 - 14
code below and then set the time-out duration (from 0-3000 seconds) by scan-
ning digits on the Programming Chart inside the back cover, then scanning
Save.
Default = 0 sec (no alarm).
Note: If you are out of range when you scan a bar code, you will receive an error
tone even if you do not have the alarm set. You receive the error tone
since the data could not be communicated to the base or Access Point or
the host.
Alarm Sound Type
You may change the alarm type for the scanner or base by scanning the
appropriate bar code below and then scanning a digit (0-7) bar code and
the Save bar code on the Programming Chart inside the back cover of this
manual.
Default = 0.
The sounds are as follows:
Setting Sound
0 3 long beeps, medium pitch
1 3 long beeps, high pitch
2 4 short beeps, medium pitch
3 4 short beeps, high pitch
4 single chirps, medium pitch
5 2 chirps, then 1 chirp, medium pitch
6 single chirps, high pitch
7 2 chirps, then 1 chirp, high pitch
Base Alarm Duration
Scanner Alarm Duration
Note: The Access Point does not
have a base alarm.
Base Alarm Type
Scanner Alarm Type
Note: The Access Point does not
have a base alarm.