Filter
Top Products
30
Figure 33. LEDs
SCANNER OPERATION
INDICATOR DESCRIPTIONS
Audible
When in operation the StratosH provides audible feedback that indicates the status of the unit and the current scan.
Eight settings are available for the tone of the beep (normal, six alternate tones and no tone) plus three volume settings.
To change the tone or volume, refer to the Changing the Beeper Tone & Volume section of this manual.
One Beep
When the scanner first receives power the white LED will flash, the blue LED will turn on and the scanner will beep once (the white
LED will remain on for the duration of the beep). The scanner is now ready to scan.
When the scanner successfully reads a bar code, the white LED will flash and the scanner beeps once (if configured to do so). If the
scanner does not beep once and the white light does not flash, then the bar code has not been successfully read.
Razzberry Tone
This is a failure indicator. Refer to failure modes on page 31.
Three Beeps - during operation
When placing the scanner in configuration mode, the white LED will flash while the scanner simultaneously beeps three times. The
white and blue LEDs will continue to flash until the unit exits configuration mode. Upon exiting configuration mode, the scanner will
beep three times and the white LED will stop flashing.
When configured, three beeps can also indicate a communications timeout during normal scanning mode.
When using one-code-configuring, the scanner will beep three times (the current selected tone), followed by a short pause, a high
tone and a low tone. This tells the user that the single configuration bar code has successfully configured the scanner.
Three Beeps - on power up
This is a failure indicator. Refer to failure modes on page 31.
Visual
White and blue LEDs are located at the top of the vertical output window.
When the scanner is
ON, the flashing or constant, illumination of the LEDs
indicates the status of the StratosH and the current scan.
No White or Blue LED
The LEDs will not be illuminated if the scanner is not receiving power from the host or transformer.
They are also not illuminated when all lasers are turned off for any reason.
Steady Blue
When all lasers are active, the blue LED is illuminated. The blue LED will remain illuminated until all lasers are deactivated.
Steady Blue and Single White Flash
When the scanner successfully reads a bar code, the white LED will flash and the scanner will beep once. If the white LED does not
flash or the scanner does not beep once, then the bar code has not been successfully read.