Filter
Top Products
9
INSTALLATION
USB (Powered by External Power Supply)
1. Turn off the host device.
2. Plug the 15-pin socket end
of the cable into the 15-pin D-Type
connector on the MS4980 (see
page 4).
3. Plug the USB end of the cable into
the host’s USB port.
4. Plug the power supply into the
power jack on the PowerLink cable.
Check the AC input requirements
of the power supply to verify the
voltage matches the AC outlet.
The outlet must be located near
the equipment and be easily
accessible.
5. Connect AC power to the
transformer.
6. The MS4980 will start to initialize. The white and blue LED will alternately
fade on and off for approximately three seconds. When the scanner has
finished initializing, the unit will flash the white LED three times while
simultaneously beeping three times. The low intensity blue LED will remain
turned on.
7. Turn on the host device. The scanner will automatically reboot after host
device is turned on.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration
Guide or MetroSet2’s help files for instructions on changing the
scanner’s factory default configuration. The scanner and host system
must use the same communication protocols.
See caution on page 5.
Figure 9.