Filter
Top Products
15
15
MANUAL SETTINGS
It is necessary to set the desired US TIME ZONE.
TIME ZONE
• Press MODE button once so that the Day of the Week abbreviation is
displayed to the right of the time; for example: pm 2:37tu
• Select the Time Zone by pressing and holding UP ( ▲) button for 3
seconds
• Keep holding UP ( ▲) button until the desired US Time Zone (Pacific,
Mountain, Central or Eastern) is highlighted on the display’s US map,
located to the right of the time display and above the day of the week
• Release the UP (▲) button. The Time Zone is set
CLOCK
• Press and hold MODE button for 3 seconds: the year will flash. Press
UP (▲) or DOWN (▼) to change flashing digits.
• After the year is set, press MODE button to confirm and move to the
next parameter (month)
• Continue setting month, date, hour, minutes, language for the day of
the week and temperature in Fahrenheit or Celsius
• Press MODE for the last time to return to the time of day with seconds,
after the last parameter is set
CLOCK ALARMS
The Wireless In/Out Thermometer has two time alarms – Weekday alarm (W)
and Single day alarm(S) - and one Ice Warning Alarm (PRE-AL).
• If Weekday (W) alarm is activated, it will sound at the set time and the
alarm icon will flash Mondays through Fridays
• If Single (S) day alarm is activated, it will sound at the set time and the
alarm icon will flash only for this specific day and will not activate on
16
subsequent days
• If Ice Warning Alarm ( PRE-AL) is activated, in will sound at the set
time and alarm icon will flash once the remote temperature for Channel
One (1) will reach 32°F(0°C) and below
NOTE
: Ice Warning Alarm can be set only if one or both - Weekday or
Single alarm - are programmed.
SETTING THE WEEKDAY (W) AND SINGLE DAY (S) ALARMS
• Press ALARM ON/OFF button once to enter into the alarms setting
mode. The default alarm is a Weekday alarm (W). The abbreviation
“OFF” with a letter “W” next to it will be displayed, if the alarm has not
been set previously
• Press and hold ALARM ON/OFF button for two seconds. The hour
digit will flash
• Adjust the hour using UP ( ▲) or DOWN ( ▼) buttons
• Press ALARM ON/OFF button again. The minute digits will flash
• Adjust the minutes using UP (▲) or DOWN (▼) buttons
• Press ALARM ON/OFF button again to confirm and the weekday alarm
time will be set
• Set Single (S) day alarm if desired in the same manner
SETTING THE ICE WARNING ALARM (PRE-AL)
If Weekday (W) or Single day (S) alarm is set, the Ice Warning Alarm (Pre-AL)
can be programmed.
• Press ALARM ON/OFF button once to enter into the Ice Warning
Alarm setting mode. The abbreviation OFF with a PRE-AL next to it will
be displayed.
• Press and hold ALARM ON/OFF button for two seconds. The number