Filter
Top Products
5 - 41
Remap a Key to a Special Function
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pull-down list.
3. Select the special function from the remapped key from the Remapped Key pull-down list. Special functions
that can be assigned are:
• Toggle SIP (soft keyboard) state between displayed and hidden
• Toggle touch screen state between enabled and disabled
• Toggle integrated keyboard backlight state between on and off
• Launch the touch screen calibration utility
4. Click OK to save the result and close the control panel.
Remap a Key to Launch an Application
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pull-down list.
3. Select Launch App1-4 from the remapped key from the Remapped Key pull-down list.
4. Click on the LaunchApp (page 5-42) tab.
5. Make sure the APP radio button is selected.
6. In the text box (LaunchApp1-4) corresponding to the number selected for Launch App1-4, enter the applica-
tion to launch.
7. If any parameters are needed for the application, click on the OPT radio button. This clears the text box
(though the application name is saved). Enter the desired parameters in the appropriate text box.
8. Click OK to save the result and close the control panel.
9. If the KeyMap tab is accessed again, the application plus any specified parameters is displayed in the Key
Sequence text box when the remapped key is again selected.
Remap a Key to Run a Command
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pull-down list.
3. Select RunCmd 1-4 from the remapped key from the Remapped Key pull-down list.
4. Click on the RunCmd (page 5-43) tab.
5. Make sure the CMD radio button is selected.
6. In the text box (RunCmd1-4) corresponding to the number selected for RunCmd1-4, enter the desired com-
mand.
7. If any parameters are needed for the command, click on the PARM radio button. This clears the text box
(though the command is saved). Enter the desired parameters in the appropriate text box.
8. Click OK to save the result and close the control panel.
9. If the KeyMap tab is accessed again, the command plus any specified parameters is displayed in the Key
Sequence text box when the remapped key is again selected.