Filter
Top Products
3 - 5
When in Hibernate Mode, the status LED:
• blinks green very slowly if external power is attached.
• is off if external power is not attached.
Power is turned off to the USB port when the Thor VM2 is in Hibernate.
System Hibernate Wakeup Events
The following event transitions the Thor VM2 from Hibernate to Full On Mode:
• Pressing and releasing the Power button.
Off Mode
By default, the Thor VM2 turns off if the user presses the power button when the Thor VM2 is On. This behavior can
be configured on the Advanced (page 5-34) tab of the Power control panel.
The Thor VM2 is also off when it is not connected to a power source and the UPS battery is depleted. However, an
internal Real Time Clock (RTC) powered by an internal battery maintains the date and time while the Thor VM2 is off.
Power Controls
Power Switch
Power Button
Power Configuration
Use the Power Options (page 5-22) control panel to select the desired power scheme/plan.
For information on the Ignition input signal see Vehicle 10-60VDC Direct Power Connection (page 4-18) and Auto-On
Control Wiring Diagram (page 4-21).
After all cables are connected, the Thor VM2 can be powered on.
There is a power switch located on the back of the Quick Mount Smart Dock. The power switch
is a rocker switch.
The power switch has a raised bump to identify the switch position even when it is hidden from
view. When the side of the switch with the raised bump is pressed, the power switch is On. If
the dock is connected to external power, the dock delivers power to the Thor VM2.
Generally, once the dock is powered On, there is no need to power it off. The dock power can
remain On even when the Thor VM2 is not attached.
The power button is located at the lower left of the Thor VM2.
If the Thor VM2 is Off, pressing the power button starts the power up
sequence.
Note: This assumes that the Thor VM2 is docked in a powered
Quick Mount Smart Dock or that the internal UPS battery has
a sufficient charge to power the Thor VM2. If no external
power is available and the UPS battery does not have a
charge, pressing the power button causes no action.
If the Thor VM2 is On, pressing the power button performs the option
selected in the Advanced tab of the Power control panel (options may
vary by OS type):
• Ignore power button press
• Prompt the user to select action
• Shut down (default, an orderly shutdown is performed)
• Standby/Sleep
• Hibernate
P
UPS
SYS
SSD