Filter
Top Products
T
o manually create a mounting location
:
1
. Locate a suitable, flat area of the dash to mount the Transducer Switch. The switch requires a depth of at least
1.5 inches (38.1 millimeters). Make sure that it will be positioned near your control head on the console of the
boat, within reach of the cables for both transducers. Also, make sure you have access behind the panel in order
to attach the cables.
2. Tape the template (included) over the desired in-dash mounting location.
3. At a location inside the dotted line on the template, drill a hole large enough to insert the blade of the
reciprocating saw. Carefully begin cutting toward the dotted line, then follow the dotted line around the
template. Remove the template when finished.
4. Insert the end of the switch through the hole until it snaps securely in place.
2. Connecting the Transducers and the Control Head to the Switch
To connect your Transducer Switch to your control head, you may have to remove the control head from the Quick
Disconnect Mounting Bracket and temporarily disassemble the connector holder.
NOTE: Your connector holder hardware may be different than the illustration, depending on your Humminbird® model. See
your control head installation guide for details.
CAUTION! Do not cut or shorten the transducer cables, and try not to damage the cable insulation. Route the cable as far
as possible from any VHF radio antenna cables or tachometer cables to reduce the possibility of interference. If the cable is
too short, extension cables are available to extend the transducer cable up to a total of 50 feet. For assistance, contact the
Customer Resource Center at humminbird.com or call 1-800-633-1468 for more information.
To connect the transducers to the Transducer Switch:
1. Access your transducer cables and insert each transducer cable connector into a Transducer Switch connector
until you hear it click into place. Refer to the illustration for guidance.
Transducer Switch Configuration
Second Transducer
Standard Transducer
Control Head
Connector Holder
Route connector to the unit
Transducer Switch
Transducer Switch
2
531870-1_A
© 2011 Humminbird®, Eufaula AL, USA.
All rights reserved.
Inserting the Cable Connector
Transducer Switch
Cable Connector
Connector Holder