Filter
Top Products
Remote Supervisor Adapter II SlimLine
Mounting bracket
Mounting bracket
Mounting bracket
retention latch
1. Read the safety information that begins on page v and “Installation guidelines”
on page 20.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 10); then, remove the
cover (see “Removing the cover” on page 22).
PCI-X slot
Power cable
3. If the riser-card assembly is an optional PCI-X riser-card assembly, disconnect
the riser-card power cable from the riser-card assembly.
4. Grasp the riser-card assembly at the front and rear edges and lift to remove it
from the server. Place the riser-card assembly on a flat, static-protective
surface.
5. Put the protective plastic cover on the Remote Supervisor Adapter II SlimLine.
6. Turn the Remote Supervisor Adapter II SlimLine so that the keys on the
connector align correctly with the connector on the system board.
7. At a downward angle, insert the free end of the adapter under the tab on the
mounting bracket, aligning the holes in the adapter with the posts on the
mounting bracket. Rotate the front end of the adapter into the front mounting
bracket, aligning the holes in the adapter with the posts on the front mounting
bracket.
28 IBM System x3250 M2 Types 4190 and 4194: User’s Guide