Filter
Top Products
16 IBM System p5 520 and 520Q Technical Overview and Introduction
Table 1-11 Models supported in S11 and S25 racks
1.5.6 The ac power distribution unit and rack content
For rack models T00 and T42, 12-outlet PDUs (FC 9188 and FC 7188) are available. For rack
models S11 and S25, FC 7188 is available.
Four PDUs can be mounted vertically in the T00 and T42 racks. See Figure 1-4 on page 17
for the placement of the four vertically mounted PDUs. In the rear of the rack, two additional
PDUs can be installed horizontally in the T00 rack and three in the T42 rack. The four vertical
mounting locations will be filled first in the T00 and T42 racks. Mounting PDUs horizontally
consumes 1U per PDU and reduces the space available for other racked components. When
mounting PDUs horizontally, we recommend that you use fillers in the EIA units occupied by
these PDUs to facilitate proper air flow and ventilation in the rack.
Machine type-model Name Supported in:
7014-S11 rack 7014-S25 rack
7037-A50 IBM System p5 185 Y Y
7031-D24/T24 EXP24 Disk Enclosure Y Y
7311-D20 I/O Expansion Drawer Y Y
9110-510 IBM System p5 510 Y Y
9111-520 IBM System p5 520 Y Y
9113-550 IBM System p5 550 Y Y
9115-505 IBM System p5 505 Y Y
9123-710 OpenPower 710 Y Y
9124-720 OpenPower 720 Y Y
9110-51A IBM System p5 510 and 510Q Y Y
9131-52A IBM System p5 520 and 520Q Y Y
9133-55A IBM System p5 550 and 550Q Y Y
9116-561 IBM System p5 560Q Y Y
9910-P33 3000VA UPS (2700 watt) Y Y
9910-P65 500VA UPS (208-240V) N Y
7315-CR3 Rack-mount HMC N Y
7315-CR3 Rack-mount HMC N Y
7026-P16 LAN-attached remote asynchronous
node (RAN)
NY
7316-TF3 Rack-mounted flat-panel console kit N Y
Note: Each server, or system drawer to be mounted in the rack, requires two power cords,
which are not included in the base order. For maximum availability, we highly recommend
that you connect power cords from the same server or system drawer to two separate
PDUs in the rack. These PDUs could be connected to two independent client power
sources.